DataLoad Community

[CharlieA]

When I type *ML I do not get the window with instructions. I have used *ML many times but the new version doesn't respond since I installed it. I'm thinking of removing the new version and installing the old version again. Anybody have any suggestions?

Thanks a Bunch!
_________________
Charlie - Maximo

[DataLoad]

Charlie,

The instruction window now appears when you type *ML( rather than just *ML. This change is because *ML can now be used in Browser Control loads without any coordinates parameters, so *ML( must be entered to show that parameters are required before DataLoad helps you work out those parameters. Type *ML( and then the message should appear.

Also in V5 we have changed the way the coordinates are captured and this should make it easier to use *ML() because finding the correct coordinates caused problems for many users in V4.

There is more information about capturing the coordinates in the *ML section of the User Guide:

http://www.dataload.com/help/macro/commands.htm#builtin

Thanks,

Jonathan Stuart