DataLoad Community Forum Index DataLoad Community

 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Dataload skips fields on the first load then works perfectly

 
Post new topic   Reply to topic    DataLoad Community Forum Index -> Macro Load Support (.dld files)
View previous topic :: View next topic  
Author Message
paul_b



Joined: 18 Aug 2010
Posts: 1
Location: Lincolnshire

PostPosted: Mon Aug 23, 2010 7:54 am    Post subject: Dataload skips fields on the first load then works perfectly Reply with quote

I am testing a load using Oracle HCM (ESR),v11 I have built in a lot of specifc delays, and am loading three data items. The first time in a session it loads the first line perfectly, then when going into the second record starts loading out of sync, as if there are not sufficient delays.
If I then clear down the loaded data from first entry and start again it works perfectly and continues to do so.
Anybody have any thoughts? Confused
Back to top
View user's profile Send private message
DataLoad
Site Admin


Joined: 15 Nov 2005
Posts: 227
Location: Dorset, UK

PostPosted: Wed Aug 25, 2010 9:08 pm    Post subject: Reply with quote

Hi,

This is probably caused because of variations in the responsiveness and speed of the Oracle form. A form can start slow and then speed up once all code has been run once, etc. Try increasing the delays further, either with your specific delays and/or by increasing the generic delays (e.g. cell processed delay) in the delays window (Tools -> Delays). If the load then works consistently, including where the load currently fails, then this proves the cause is that the form is initially running slowly. If that is the case then you could keep the delays high or you could enter 2 records and clear the form before loading the bulk of your data so that the form is fully "initialised" before the main load. If you are using DataLoad Pro then turn on Load Control and DataLoad will automatically the delays and vary them according to Oracle's readiness and that will fix this issue.

Thanks and regards,

Jonathan Stuart
Back to top
View user's profile Send private message Send e-mail Visit poster's website
Display posts from previous:   
Post new topic   Reply to topic    DataLoad Community Forum Index -> Macro Load Support (.dld files) All times are GMT
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group