DataLoad Community Forum Index DataLoad Community

 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

New DataLoad does not save and proceed

 
Post new topic   Reply to topic    DataLoad Community Forum Index -> Macro Load Support (.dld files)
View previous topic :: View next topic  
Author Message
usdt



Joined: 22 Jun 2010
Posts: 1
Location: Carpinteria, CA

PostPosted: Wed Jun 23, 2010 4:14 pm    Post subject: New DataLoad does not save and proceed Reply with quote

When using the new dataload in Oracle the *sp (save and proceed) command does not work. After query a record, using *ml() to position cursor on field to update, entering data, and then using *SP to save and proceed.

Focus never leaves the last updated field. So when the next line of data load is processed the next value to query is loaded into the last updated field.

I've tried numerous ways to remedy this:
1. Reposition the cursor to the key field before the *sp.
2. Reposition the cursor to the key field and use the *save
3. Repostion the cursor to the key field as the first command
4. Use tabs to get back to the key field before the *sp

In every case the focus jumps back to the last updated field when executing the next line.

Old dataloads defined using the old version of datload seem to work fine.
However, if i try to modify one with new coordinates, it assumes the same behavior listed above.
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    DataLoad Community Forum Index -> Macro Load Support (.dld files) All times are GMT
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group